Refrigerated Trailer Operation Guide
Table of Contents
Operating Procedures
Display
- ON/OFF Switch
- SET Switch
- Spanner (Included)
- Latch
Switching the refrigeration unit On/Off
- Use spanner (4) to unlock the latch (5). Press the button ON/OFF to activate the trailer refrigeration unit.
Setting Target Temperature (Set Point)
- Use spanner (4) to unlock the latch (5).
- Open the protection cover.
- Switch on the refrigeration unit by pressing the ON/OFF button.
- Press SET once. The display (1) shows “SET” to indicate the change into Set-Mode. This allows you to change the target temperature inside the carrier.
- Press SET again. The display (1) now shows the current setting of the target temperature.
- Adjust the target temperature by pressing UP for a higher temperature or DOWN for a lower temperature. The value changes in steps of 0, 1° when you press less than 1 second. When you press and hold the button, the value increases or decreases as long as you press or until the maximum of 50°F or minimum of 0° is reached.
- Confirm your desired temperature by pressing SET again. You hereby save and apply the new target temperature setting and leave the Set-Mode. The display (1) shows the current temperature inside the carrier.
GOVI Operating Elements
Display
The display (1) serves to choose and to show the nominal temperature.
ON / OFF
The ON / OFF switch (2) enables users to switch on and off the refrigeration unit.
Control (SET) Switch
Setting Nominal Temperature (3).
UP / Defrost
To increase the temperature/manual defrost (4).
DOWN/Light
To lower the temperature / enable to switch the light on / off (5).
GOVI Breakdown
The following contains information about the operating elements and procedures for your GOVI refrigeration unit.
- Main Cover
- Evaporator (with Refrigerant in the System)
- Protection Cover
- Air Intake (Do Not Obstruct)
- Air Outlet (Do Not Obstruct)
Main Cover (1)
The main cover (1) covers the outer parts of the refrigeration unit.
Evaporator (2)
A liquid gas is used inside the pipes of the refrigerating unit. Refrigerants usually need special attention in handling. This refrigeration unit works with a hermetic piping system. Under normal conditions, there is no need to recharge refrigerant. Some States may have statutory provisions and regulations for disposal of refrigerants. Make sure you know and follow these statutory provisions and regulations when changing or disposing of refrigerants.
GOVI Diagram 1
Protection Cover and Target Temperature
The protection cover (3) is a cover that opens like a window. The lid window shields the control unit from harsh weather and impedes unintended changes of the settings. You need a turn spanner (included in delivery) to open the lid.
The target temperature is the desired temperature inside the cargo box. You can adjust the target temperature by following the below instructions.
Air Intake (4)
Do not obstruct air intake!
Air Outlet (5)
Do not obstruct air outlet!
